AMF / ATS Controller, Generator
DTA-201 Generator AMF/ATS Control Card With Heater & Low Oil Pressure & High Temperature Switch Safety
Auto Main Failure and Automatic load transfer With Heater & Low Oil Pressure & High Temperature Switch Safety
- Microprocessor controled
- The Heater Turns on for About 9 Seconds Before Turning on the Self
- Self On/Off Time Setting
- Genset On Load Time & Genset Off Load Time
- Main On Load Time
- Generator Cool Down Time Built in 14 Seconds
- Failed To Start Indication LED
- Excellent Ability to Start and Stop the Generator
- DC Supply: 12 Volts, (+) and (-) Terminals.
- Indicators to show card performance
- Capability to transfer loads without DC 12 volts
- There is an extra Switch to start and stop the generator manually
₨4,000
The DA201 unit which is specially designed for Disele Genset.
It is used to start and stop the Genset in automatic or manual mode auto/manual switch on the panel.
DTA201 is properly start & stop the genset in very Efficient Sequenc.
This Card Also Has Four variables that are used to increase or decrease the tiem genset & mains.
DC Supply: 12 volts, (+) and (-) terminals.
Digitech Automation.
solution providers Automation,Hardware & firmware which is one of the Best &Trusted
company in pakitan.
for further details please contact # 0302 4459989.
also visit our facebook page “Digitech Automation LHR”
Head Office: Suite No.11,1st Floor Makkah Centre.
45 Mall Road Lahore. Ph.04237311323,0302 4459989.
Branch: Shop No.2 Al-Khalil Center 16-A Hall Road Lahore.
Phone No.042 37365346,0300 9499391,0321 4365594
0321 4355471,0323 4509860.
Based on 0 reviews
Be the first to review “DTA-201 Generator AMF/ATS Control Card With Heater & Low Oil Pressure & High Temperature Switch Safety”
Related products
-
AVR, Generator
SX460 AVR – Automatic Voltage Regulator Imported
- SX460 AVR – Automatic Voltage Regulator – Exact Generic Replacement.
- INPUT: Voltage: Jumper selectable 95-132V ac or 190-264V ac, Frequency: 50-60 Hz nominal, Phase: 1
- OUTPUT: Voltage: Max 90V dc at 207V ac input, Current: Continuous 4 A dc, Intermittent 6 A for 10 secs, Resistance: 15 ohms minimum.
- Regulation: +/-1.0% * Thermal drift: 0.05% per deg. C change in AVR ambient.
- Unit power dissipation: 10 watts maximum – Build up voltage：4 Volts @ AVR terminals.
- INPUT
Voltage: 220V AC Jumper selectable
Frequency: 50-60Hz nominal
Phase: 1OUTPUT
Voltage: max 90V DC at 207V AC Input
Current: continuous 4 A DC
Resistance: 15 ohms minimum
SKU: n/a -
AVR, Generator
DTA-625 AVR Automatic Voltage Regulator For Generator
Model No DTA-625
- Inpt Voltage: 220V AC
- Phase: Single 1
- Frecuency: 50hz – 60Hz
- Output Voltage: 0V To 90V Dc Maximum
- Current Max: 25A DC
- Continuous 13A-Dc Excitation Current
- Controls: Volt , Stab
- Quick response ( 25 ms )
- Thyristor Control Technology
- Suitable for 10 KVA 1000 KVA Brushless Generator
- Requires Only 4V-AC Residual Voltage to Buildup Alternator Voltage
- Easy to Install
- Repairable
- Low Cost
SKU: n/a -
AMF / ATS Controller, Generator, Genset Starting Module
DTA-264 Generator AMF/ATS Control Module With Heater & Low Oil Pressure & High Temperature, Low High Voltage, Over Under frequency Safety
AMF / ATS Controller, Generator, Genset Starting ModuleDTA-264 Generator AMF/ATS Control Module With Heater & Low Oil Pressure & High Temperature, Low High Voltage, Over Under frequency Safety
- Auto Main Failure and Automatic load transfer With Safety
- Microprocessor controled
- Manual start Optional
- Front panel mounting
- Front panel programming
- Configurable timers
- Ldc Display
- Main Shutdown timer
- Heater On Timer
- Crank On Timer
- Crank Rest Timer
- Generator on Load Timer
- Size : 165mm , 125mm , 45 mm
- Penal Cutout Size: 113mm X 152mm
- Generator Off Load Timer
- Main On Load Timer
- Generator Cooling Timer
- Choke On Timer
- Frecuency Delay Timer
- Frecuency High Limit
- Frecuency Lower Limit
- Warmup Timer
- Numebr of Start Attempts
- Main Voltage High Limit
- Main Voltage Lower Limit
- Generator Over Voltage high Limit
- Generator Under Voltage Limit
- DC Supply: 12V & 24volts, (+) and (-) terminals.
SKU: n/a -
AMF / ATS Controller, Generator
DTA-210 AMF/ATS 2 Wapda & 1 Generator Automatic Load Transfer and Generator Start/Stop Unit
AMF / ATS Controller, GeneratorDTA-210 AMF/ATS 2 Wapda & 1 Generator Automatic Load Transfer and Generator Start/Stop Unit
- Aoutmatic 2 main Lines And Generator Control Card
- This card is Specially Designed to Control Two WAPDA Meters and One Generator
- Meter 1 and Meter 2 automatically switch with time Delay Setting
- In case of both line shutdown, it starts the generator itself and shifts the load to the generator.
- If in-wapda 2 comes on while the generator is running, it shuts down the generator and turns it into Metter 2.and shifts the load to the Metter 2.
- In case of both Line 1 and Line 2 coming, the load of Line 1 will be transferred automatically
- Variables to Onload line one, line two, and line three
- Self On/Off Time Setting
- Genset On Load Time & Genset Off Load Time
- Main On Load Time
- Generator Cool Down Time
- Failed To Start Indication LED
- Excellent Ability to Start and Stop the Generator
- DC Supply: 12 Volts, (+) and (-) Terminals.
- Indicators to show card performance
- Capability to transfer loads without DC 12 volts
SKU: n/a
There are no reviews yet.